Wong, H 
ORCID: 0000-0003-1717-2653, Dawson, K ORCID: 0000-0003-3249-8328, Ravi, GA, Howlett, L, Jones, RO and Sutcliffe, CJ
(2019)
Multi-Laser Powder Bed Fusion Benchmarking-Initial Trials with Inconel 625.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, 105 (7-8).
pp. 2891-2906.
|
Text
Wong2019_Article_Multi-LaserPowderBedFusionBenc.pdf - Published version Download (8MB) | Preview |
Abstract
<jats:title>Abstract</jats:title> <jats:p>Production rate is an increasingly important factor in the deployment of metal additive manufacturing (AM) throughout industry. To address the perceived low production rate of metal AM systems based on single-laser powder bed fusion (L-PBF), several companies now offer systems in which melting has been parallelised by the introduction of multiple, independently controlled laser beams. Nevertheless, a full set of studies is yet to be conducted to benchmark the efficiency of multi-laser systems and, at the same time, to verify if the mechanical properties of components are compromised due to the increase in build rate. This study addresses the described technology gaps and presents a 4-beam L-PBF system operating in “single multi” (SM) mode (SM-L-PBF) where each of the four lasers is controlled so that it melts all of a particular components’ layers and produces specimens for comparison with standard L-PBF specimens from the same machine. That is all four lasers making all of some of the parts were compared to a single-laser manufacturing all of the parts. Build parameters were kept constant throughout the manufacturing process and the material used was Inconel 625 (IN625). Stress-relieving heat treatment was conducted on As-built (AB) specimens. Both AB and heat-treated (HT) specimen sets were tested for density, microstructure, tensile strength and hardness. Results indicate that the stress-relieving heat treatment increases specimen ductility without compromising other mechanical properties. SM-L-PBF has achieved a build rate of 14 cm<jats:sup>3</jats:sup>/h when four 200 W lasers were used to process IN625 at a layer thickness of 30 μm. An increase in the build rate of 2.74 times (build time reduction: 63%) has been demonstrated when compared to that of L-PBF, with little to no compromises in specimen mechanical properties. The observed tensile properties exceed the American Society for Testing Materials (ASTM) requirements for IN625 (by a margin of 22 to 26% in the 0.2% offset yield strength). Average specimen hardness and grain size are in the same order as that reported in literatures. The study has demonstrated that a multi-laser AM system opens up opportunities to tackle the impasse of low build rate in L-PBF in an industrial setting and that at least when operating in single mode there is no detectable degradation in the mechanical and crystallographic characteristics of the components produced.</jats:p>
| Item Type: | Article |
|---|---|
| Uncontrolled Keywords: | Additive manufacturing, Multi-laser powder bed fusion, Selective laser melting, Mechanical properties, Inconel 625 |
| Depositing User: | Symplectic Admin |
| Date Deposited: | 11 Nov 2019 09:39 |
| Last Modified: | 19 Jan 2023 00:20 |
| DOI: | 10.1007/s00170-019-04417-3 |
| Related URLs: | |
| URI: | https://livrepository.liverpool.ac.uk/id/eprint/3061152 |
Dimensions
Dimensions
